#FUSION 360 POST PROCESSOR VERIFICATION#
I don’t have an LCD hooked up so I can’t tell if its just waiting on a verification like Bobby’s was.
#FUSION 360 POST PROCESSOR CODE#
There are some errors in the code listed, G20 and M80 but those look the same as what Bobby listed above. The ETE in the bottom right lists 53 seconds.
Once I start the print, a little g-code runs through the bottom window but nothing happens. Repetier list the print time as 1 Minute 1 second (just a test square), before I hit start. I then open the file in repetier, make sure its on the board and look at the travel and all seems right. I’ve downloaded the newest version of the pp, have it installed and it seems to be working to spit out a proper G-Code. I can run gcode from ESTLcam without problems and can manually jog through repetier without issues. Hi guys, I was hoping for a little help with Fusion 360 pp.įirst some basics: Standard MPCNC, no lcd, no modifications, not using duel endstops, 18x18 build area.
0 kommentar(er)
